Trick or treat goodness (part 2)

Halloween spider wreath

This post could be alternately titled “Fun with plastic spiders & a hot glue gun”. There were a couple more decorations that I made up last Halloween that I’d like to share with you. My absolute favourite decoration was by far our wreath. It was super simple to make and also fairly inexpensive. You will need a black wreath (which I picked up on sale at Michaels), a bag of plastic Halloween rings (most dollar stores have them), a small pair of wire cutters, hot glue gun, and some wide Halloween wired ribbon. Here’s all you need to do to make a creepy, fun wreath:

Plastic rings, wire cutters, hot glue gunCutting plastic spider ring

1. Sort your plastic rings (I only used the spiders and mainly used the orange ones)
2. Using small wire cutters, snip off the band of each ring
3. Apply a small amount of hot glue on the back of the spider
4. Squeeze the spider onto the wreath (be careful not to burn yourself on the glue)
5. Repeat until you have covered your wreath in as many spiders as you like
6. Using the wired ribbon make a pretty bow (I’m really not very good at this, so any instructions Gluing plastic spiderPlastic spider ribbonyou can find online about making a bow, will be better than anything I can tell you)
7. Once you’re satisfied with your bow, glue some spiders on it
8. Attach the bow on the bottom of your wreath either by hot gluing it or tying it on with thread (depends on how big or what style of bow you make)

While you have the glue gun warmed up and those plastic rings handy, you can also make up some simple clothespin decorations, which I found inspiration for on Martha’s site:

1. Last year I ran out of time (I started making these about an hour before guests began arriving at our Halloween party), but I would suggest either painting or spray painting the clothespins black before you start and let dry
2. Take some plastic rings and snip the band off of each, as done above with the wreath project
3. Apply a dab of hot glue to the back of each ring
4. Squeeze onto the “front” of the clothespin (again be cautious of getting hot glue on your fingers when you do this)

Now you have some creepy decorations to clip onto the edge of bowls or where ever you can think to clip them. I like they way they dress up the treat table at a party and you can’t beat how simple they are to make.

Clothespins and plastic ringsHalloween clothespin decorationHalloween clothespin decoration

Share this:

Leave a Reply

Your email address will not be published. Required fields are marked *